SS22D03 DPDT Metal-Shielded PCB Slide Switch
The SS22D03 is a compact DPDT (2P2T) ON-ON slide switch designed for through-hole PCB mounting. Its metal-shielded housing, tall forked actuator and two independent switching circuits make it suitable for signal selection, mode switching and low-power electronic control applications.
The switch provides non-shorting contact timing, six electrical terminals and two mechanical support tabs for stable PCB installation.
Key Features
• DPDT / 2P2T contact configuration
• ON-ON two-position switching function
• Non-shorting contact timing
• Rated at 0.3A 50VDC
• Six through-hole electrical terminals
• Two additional mechanical PCB support tabs
• Tall forked vertical actuator
• 2.0 mm actuator travel
• Compact metal-shielded housing
• Suitable for PCB-mounted electronic equipment
• Samples and bulk-order quotation available
Technical Specifications
• Model: SS22D03
• Switch type: Mini slide switch
• Contact configuration: DPDT / 2P2T
• Switching function: ON-ON
• Contact timing: Non-shorting
• Electrical rating: 0.3A at 50VDC
• Contact resistance: 30 mΩ maximum
• Insulation resistance: 100 MΩ minimum
• Dielectric strength: 500VAC for 1 minute
• Operating force: 250 ± 100 gf
• Operating life: 10,000 cycles
• Operating temperature: -25°C to +85°C
• Actuator travel: 2.0 mm
• Actuator size: Approximately 2.0 mm square
• Body footprint: Approximately 8.6 × 6.9 mm
• Terminal arrangement: Two rows of three electrical terminals
• Terminal pitch: 2.0 mm
• Row spacing: Approximately 2.5 mm
• Mounting method: Through-hole PCB mounting
• Housing: Metal-shielded construction
Typical Applications
• Consumer electronics
• Audio and video equipment
• Signal and mode selection circuits
• Test and measuring instruments
• Small control panels
• Communication equipment
• Industrial electronic devices
• PCB control modules
Ordering Information
Please provide the required quantity, application, electrical requirements and any actuator-height or packaging requirements when requesting a quotation. Samples can be supplied for mechanical and electrical evaluation.
Final dimensions, materials and electrical performance should be confirmed against the approved technical drawing and production sample before mass production.
